Gate Operators : D-SG

Slide Gate Operators

Model D-SG Slide Gate Operator

Technical Specifications:

  • Power requirements: 115V, 1 Phase
  • Available in 588 watts (1/2 HP equivalent)
  • Class II low voltage control circuit.
  • Maximum gate weight: 2,000 lbs
  • Maximum gate width: 50 feet
  • Maximum cycles per hour: 60cph / Continuous use
  • Gate speed: 9 inches per second
  • UL 325 Listed for use in Class I through IV application.
  • Shipping weight: Approx. 205 lbs

Optional Equipment:

  • Radio Controls
  • Safety Edge (contact safety sensor)
  • Photo Cell (non-contact safety sensor)
  • Push Buttons with Keyed Lockout
  • Loop Detector
  • Magnetic Gate Lock
  • Gear Box Heater (for cold climates)
  • Interior and Exterior Control Stations:
    • Push Buttons
    • Push Button with Keyed Lockout
    • Key Switches
  • Padlockable Option to secure cover for increased tamper proof protection
  • Polyethylene rust and dent proof cover

Electrical Specifications:

  • Solid state controller with diagnostic LED’s to indicate all input and output functions
  • Built-in Radio Receiver
  • 3 slots for Plug-in Loop Detectors
  • Adjustable Closing Timer
  • Maximum Run Timer for equipment protection
  • Master/Slave option with dedicated terminal connection provided
  • Easy Left/Right changeover
  • Spike suppressing circuitry for surge and lightning protection.
  • Magnetic gate lock circuitry with control relay
  • External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors
  • Internal On/Off power switch
  • 115 VAC, Convenience receptacle
  • NEMA 1 three-button control station included

Mechanical Specification:

  • Heavy duty #11 Ga. Galvanized steel frame providing a strong and durable unit.
  • 40:1, oil bath type, gear reducer for long service and smooth, quiet operation.
  • Heavy duty #50 drive chain with a spring loaded tensioning system for smooth starts, stops, and reversals.
  • Heavy duty pillow block type ball bearings supporting output drive shaft and enabling extended endurance under heavy loads with low maintenance.
  • Padlockable drive disconnect with brass slide for manual operation in case of power failure.
  • Positive chain driven rotary limit switches for precision gate positioning. Settings are never affected by manual operation.
  • Post or pad mountable for easy installation.

© 2018 V.E. Power Door Co., Inc.