Slide Gate Operators

Model RSG Slide Gate Operator



Technical Specifications:

  • Power requirements: 115 Volts, 1 phase.
  • Class 2 low voltage control circuit.
  • Available horse power: 1/2 HP.
  • Maximum gate weight: 350 LBS.
  • Maximum cycles per hour: 10 CPH.
  • Maximum gate width: 14 feet.
  • Gate speed : 12 inches per second.
  • UL 325 Listed for use in Class I through IV application.
  • Shipping weight: approx. 90 LBS.

Optional Equipment:

  • Radio Control.
  • Safety Edge (contact safety sensor).
  • Photo Cell (non-contact safety sensor).
  • Loop Detector.
  • Card Key Reader.
  • Magnetic Gate Lock.
  • Interior and Exterior Control Stations:
    • Push Buttons
    • Push Button with Keyed Lockout
    • Key Switches
  • Three Second Advance Audio Warning Signal available upon request.

Electrical Specifications:

  • Solid state P.C. board with Custom Programmed Micro Processor for state of the art control.
  • External control input terminal connections for:
    • Radio Receiver
    • Push Button Control Station
    • Key Switches
    • Loop Detector
    • Card Key Readers
    • Telephone Entry Systems, Etc.
  • Timer to close with 0-60 sec. Adjustment standard.
  • Longer timer available upon request.
  • Maximum run timer for equipment protection (self adjusting).
  • Master/Slave option with dedicated terminal connection provided.
  • Easy Left/Right changeover.
  • Time delay on reverse to insure smooth gate motion and less stress on equipment.
  • Spike suppressing circuitry for surge and lightning protection.
  • Electrical dynamic brake for precise gate positioning.
  • Integral current sensing anti-entrapment circuitry with independent opening and closing sensitivity adjustment.
  • External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors.
  • 1/2 HP., 115 Volt AC, 5.5 Amp., 1 phase, instant reversing, switchless, PSC motor, with thermal overload protection for smooth, quiet operation.
  • Internal On/Off power switch.
  • NEMA 1 three-button control station included.

Mechanical Specifications:

  • Heavy duty #11 Ga. Galvanized steel frame providing a strong and durable unit.
  • Hard shell baked-on weather resistant powder coating with an attractive textured finish for years of aesthetic protection from the elements.
  • Industrial V-belt primary reduction for smooth quiet operation.
  • #65 Sprocket and roller chain arrangement for final drive reduction.
  • Oil impregnated brass bearings supporting output drive shaft, for dependable service with low maintenance.
  • Heavy duty #41 roller chain driving gate.
  • Easy pull and latch drive disconnect with solid brass slide for manual operation in case of a power failure.
  • Positive, chain driven rotary limit switches for precision gate positioning. Never affected by manual operation.
  • Post or pad mountable for easy installation.

©2012 V.E. Power Door Co., Inc.