Slide Gate Operators

Model SG Slide Gate Operator

Technical Specifications:

• Power requirements:
  115/230V, 1 phase
  230/460V, 3 phase.
• Class 2 low voltage control circuit.
• Available horse power: 1/2 to 1-1/2 HP.
• Maximum gate weight: 1800 LBS.
• Maximum cycles per hour: 30 CPH.
• Maximum gate width: 50 feet.
• Gate speed: 11 inches per second.
• UL 325 Listed for use in Class I through IV application.
• Shipping weight: approx. 235 LBS.

Optional Equipment:

• Radio Control.
• Safety Edge (contact safety sensor).
• Push Buttons with Keyed Lockout
• Loop Detector.
• Card Key Reader.
• Magnetic Gate Lock.
• Gear Box Heater (for cold climates).
• Thermostatically Controlled Cooling Fan (for hot climates).
• Interior and Exterior Control Stations:
  
  • Push Buttons
  • Push Button with Keyed Lockout
  • Key Switches
• Padlockable Option to secure cover for increased tamper proof protection.
• Foot disconnect system.
• Polyethylene rust and dent proof cover.
• Torque limiting clutch.

Electrical Specifications:

• Solid state control board with diagnostic LED’s to indicate all input and output functions.
• External control input terminal connections for:
  
  • Radio Receiver
  • Push Button Control Station
  • Key Switches
  • Loop Detectors
  • Card Key Readers
  • Telephone Entry Systems, Etc.
• Timer to close with 0-60 sec. Adjustment standard. Longer timer available upon request.
• Maximum run timer for equipment protection (self-adjusting).
• Master/Slave option with dedicated terminal connection provided.
• Easy Left/Right changeover.
• Time delay on reverse to insure smooth gate motion and less stress on equipment.
• Spike suppressing circuitry for surge and lightning protection.
• Emergency control enabling circuitry for safety with security.
• Electrical dynamic or solenoid brake for precise gate positioning.
• Magnetic gate lock circuitry with control relay.
• Integral, speed sensing, anti-entrapment circuitry with independent opening and closing sensitivity adjustment.
• External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors.
• 1 Phase or 3 phase instant reversing motors with thermal overload protection and high speed ball bearings for smooth, quiet operation. Single phase motors available in capacitor start or switchless PSC styles.
• Internal On/Off power switch.
• Two grounded 115 Volt AC, 15 Amp. Convenience receptacles (115V units only).
• NEMA 1 three-button control station included.
• Selectable three second advanced audio warning signal

Mechanical Specification:

• Heavy duty #11 Ga. Galvanized steel frame providing a strong and durable unit.
• 40:1, oil bath type, gear reducer for long service and smooth, quiet operation.
• Heavy duty #50 drive chain with a spring loaded tensioning system for smooth starts, stops, and reversals.
• Heavy duty pillow block type ball bearings supporting output drive shaft and enabling extended endurance under heavy loads with low maintenance.
• Padlockable drive disconnect with brass slide for manual operation in case of power failure.
• Positive chain driven rotary limit switches for precision gate positioning. Settings are never affected by manual operation.
• Post or pad mountable for easy installation.