Gate Operators : RSW

Swing Gate Operators

Model RSW Swing Gate Operator

The RSW Operator controls vehicular swinging gates up to 350 pounds, with a maximum width of 12 feet. Units can cycle up to 12 times per hour, with a gate speed of 11 seconds from open to close.

Specifications & Features:

  • PSC Motor
  • Available horse power: 1/2 HP
  • Power requirements: 115 Volts, 1 Phase
  • Class II low voltage control circuit
  • Gate Capacity: 350 lbs, 12 ft wide, up to 12 cycles per hour
  • Travel Speed: 11 Seconds to full open or full close
  • UL 325 listed for use in Class I through IV applications
  • Heavy duty #11 Ga. Galvanized steel frame providing a strong and durable unit
  • Hard shell, baked-on black weather resistant powder coating
  • Industrial V-belt primary reduction for smooth, quiet operation
  • #65 Sprocket and roller chain arrangement for final drive reduction
  • Oil impregnated brass bearings, supporting output drive shaft, for dependable service with low maintenance
  • Drive arm easily disconnected for manual operation in case of a power failure
  • Easy adjustable limit switch cams for precision gate positioning
  • Soft start and stop at open and close limits of travel
  • Post or pad mountable for easy installation
  • Solid state P.C. board with Custom Programmed Micro Processor for state of the art control
  • External control, input terminal connections for:
    • Radio Receiver
    • Push Button Control Station
    • Key Switches
    • Loop Detectors
    • Card Key Readers
    • Telephone Entry Systems, Etc.
  • Timer to close with 0-60 sec. Adjustment standard (Longer timer available upon request)
  • Maximum run timer for equipment protection (self adjusting)
  • Master/Slave option with dedicated terminal connection provided
  • Easy Left/Right changeover
  • Time delay on reverse to ensure smooth gate motion and less stress on equipment
  • Spike suppressing circuitry for surge and lightning protection
  • Electrical dynamic brake for precise gate positioning
  • Integral, current sensing, anti-entrapment circuitry with independent opening and closing sensitivity adjustments
  • External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors
  • Internal On/Off power switch
  • NEMA 1 one-button control station included
  • Shipping Weight: Approximately 83 lbs
  • Shipping Dimensions: 24" x16" x 16"

Optional Equipment:

  • Radio Control
  • Safety Edge (contact safety sensor)
  • Photo Cell (non-contact safety sensor)
  • Loop Detector
  • Card Key Reader
  • Interior and Exterior Control Stations:
    • Push Buttons
    • Push Buttons with keyed Lockout
    • Key Switches
  • Three Second Advance Audio Warning Signal, available upon request

© 2018 V.E. Power Door Co., Inc.